PDA

View Full Version : Shared Bearing - Brill!

sellam
19th May 2009, 11:21 AM
Tony,
Thanks for the shared bearing facility - Brill!

Regards,
Steve Ellam:cool:
sellam
27th May 2009, 03:03 PM
Well, there is a small problem... A double beam sharing a beaing at each end. The description on R1 in the text box reads R1 from the beam that has been brought forward - good.
The other end when adding the beam R2 does not fill the text box for that end but overwrites the R1 text box as R2.
Other than that its brill!
Tony Bryer
6th June 2009, 12:15 AM
Well, there is a small problem... A double beam sharing a beaing at each end. The description on R1 in the text box reads R1 from the beam that has been brought forward - good.
The other end when adding the beam R2 does not fill the text box for that end but overwrites the R1 text box as R2.
Other than that its brill!

This is fixed in SuperBeam 4.55d and ProSteel 5.34d - thank you for drawing it to our attention.