Connection diagram

[H&H]

I can't disable the printing of the connection sketch even though I have clicked the appropriate button, every time I print out the sketch is printed too.

Also is it possible to move the connected beam down to the bottom flange of the supporting beam rather than tbeing at the top?

I have a situation where the connected beam must be at the bottom flange level and the printout is confusing the Architect! Hence paragraph 1

Any help much appreciated

[H&H]

OK sorted how to turn off the diagram but does anyone know how to move the joint down to the lower flange or is that not possible?

Thanks

[sellam]

I have had this problem with architects.... I tell them to turn the page upside down! :rolleyes:

[Tony Bryer]

OK sorted how to turn off the diagram but does anyone know how to move the joint down to the lower flange or is that not possible?

Thanks

No the current routine for beam to beam connections always assumes that the tops of the supported and supporting beam are level. Currently I don't have any plans to change this.