View Single Post
Old 29th November 2017, 03:31 PM   #1
catman
Member
 
Join Date: Apr 2017
Posts: 4
Default Part wall load on beam

Hi
If i have a steel beam say 5mtrs long and a wall set at one end 2mtrs long on top of the beam , how do i tell the program this is the case.
If I added the wall height the program will assume that the wall is 5mtrs long x the height x the kn load applied
The area for identifying start and finish of the load are greyed out

Can anyone throw some light on this

Rgds
catman is offline   Reply With Quote