Greentram Software Support Forums  

Go Back   Greentram Software Support Forums > ProSteel > User feedback and requests

User feedback and requests User comments on ProSteel and requests for future enhancements

Reply
 
Thread Tools Display Modes
Old 17th February 2012, 11:12 AM   #1
L.D.Sutherland
Member
 
Join Date: Jul 2008
Posts: 9
Default Column - rhs used flat - print out

TONY I trust you are well & well tanned !

This is only or a Screen or a Print tidying up comment for you not a technical one.

When you design a FLAT RHS as a Column:

On screen
The diagram section stays Vertical instead of Horizontal and the load locations are fine.

In the print out
The member shape is fine but the load locations 1(part lost) and 2 land inside the rectangle instead of above and below it.

Regards LESLIE
L.D.Sutherland is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



All times are GMT. The time now is 04:33 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2011 Greentram Software Pty Ltd, Melbourne, Australia