Greentram Software Support Forums  

Go Back   Greentram Software Support Forums > ProSteel > User feedback and requests

User feedback and requests User comments on ProSteel and requests for future enhancements

Reply
 
Thread Tools Display Modes
Old 13th May 2015, 04:42 PM   #1
factory-fit
Member
 
Join Date: Sep 2008
Location: North Newbald
Posts: 22
Default Double negatives

Interesting glitch popped up when entering negative number for a load that extends to the 'backside' of R1; I was adjusting a series of cells which all therefore contained the 'minus' dimensions for a cantilever.

For convenience copied the dimension cell's value into memory, then double clicked in the cells below requiring editing and used right mouse click to paste the value into each of them.

Only after experience showed the column values were inconsistent and 'R1' was too low, did a recheck show that doing it this way left the cell with TWO minus signs before the value, which the software was naturally ignoring.

cheers

Kevin A
factory-fit is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



All times are GMT. The time now is 09:36 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2017, Jelsoft Enterprises Ltd.
Copyright 2011 Greentram Software Pty Ltd, Melbourne, Australia