Greentram Software Support Forums  

Go Back   Greentram Software Support Forums > ProSteel > Support

Support Technical and other questions related to the use of ProSteel

Reply
 
Thread Tools Display Modes
Old 18th September 2019, 11:18 AM   #1
Adrian
Member
 
Join Date: Apr 2019
Posts: 3
Default Ridge beam crank plates

Hello
Thirty-plus years ago the loft conversion place I worked at had a couple of plate details for doing a cranked ridge beam. My copies have long disappeared.
Normally the ridge beam can be supported at each end, either by being built into a wall, posted in a stud wall or posted in the room, so the beam was always a straight beam.
I've got a job with a small rear dormer and rather than build the hip up into a gable, they are insisting on keeping the roof a full hipped roof.
The client (understandably!) doesn't want a post in the room so the ridge beam must follow the pitch of the side roofslope.
Is there a way to calculate crank plates? Usually 10-15mm thick plates, maybe 500-600mm long (each leg) with one on each side of the cut timber ridge beam with multiple bolts through the lot.
Thanks in advance.
Adrian is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



All times are GMT. The time now is 12:09 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2019, Jelsoft Enterprises Ltd.
Copyright 2011 Greentram Software Pty Ltd, Melbourne, Australia