Greentram Software Support Forums  

Go Back   Greentram Software Support Forums > SuperBeam > Support

Support Technical and other questions related to the use of SuperBeam

Reply
 
Thread Tools Display Modes
Old 22nd August 2011, 10:22 AM   #1
M J Tierney
Member
 
Join Date: Aug 2011
Posts: 1
Smile Removing the corner wall

Removing the corner of a building will require 2 beams to support the
two wall above...Will Superbeam cover these calculations?
M J Tierney is offline   Reply With Quote
Old 22nd August 2011, 12:11 PM   #2
Tony Bryer
Administrator
 
Join Date: Apr 2008
Location: Melbourne, Australia
Posts: 824
Default Re: Removing the corner wall

Yes, you can do this with SuperBeam but it needs care, both at the design stage and when the work is done.

The usual arrangement is one UC or twin UBs supporting one side of the corner, spanning from the remaining wall to the corner, where it/they are picked up by steel(s) running in the other direction. If the longer span is supported by twin UBs you need to take account of the fact that the point load from the short steel(s) probably acts on one of them only, so you may well end up with a twin beam using two different sections. You also need to design the connection between the intersecting beams. Lastly, of course, you need to be sure that you have proper supports under each of the beam bearings.

When it comes to executing the work, proper propping of the wall above is vital, and it is also essential to preload the beam(s) otherwise the load will progressively transfer to the steels causing progressive deflection and cracking of the wall over.

In short this is probably not a hugely complicated piece of design but unless you are completely confident of your ability to work through the design I would hand it over to someone more experienced.
__________________
Tony Bryer, Greentram Software Pty Ltd
Tony Bryer is offline   Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is Off
HTML code is Off



All times are GMT. The time now is 08:21 AM.


Powered by vBulletin® Version 3.8.5
Copyright ©2000 - 2018, Jelsoft Enterprises Ltd.
Copyright 2011 Greentram Software Pty Ltd, Melbourne, Australia